- 1). Turn off the dishwasher breaker in your service panel.
- 2). Open the dishwasher door and remove the screws securing the dishwasher's control panel to the door, located on the top and sides of the inner door panel.
- 3). Close the dishwasher door, but do not latch it.
- 4). Pull the control panel off of the dishwasher door.
- 5). Depress the tabs securing the circuit board cover to the inside of the control panel using a flat-head screwdriver. It may be necessary to insert the screw driver into the bottom of the control panel to access the bottom tab. Remove the circuit board cover.
- 6). Remove the thermal fuse from the side of the circuit board by using a small flat-head screwdriver to release the tabs.
- 7). Depress the tabs on the side of the control panel ribbon connector, located on the left-side of the circuit board, and remove the control panel ribbon connector.
- 8). Depress the tabs securing the circuit board to the control panel using a flat-head screwdriver, and then remove the circuit board. On some models of Frigidaire dishwashers, the circuit board may be secured using screws, rather than tabs.
- 9). Insert the new circuit board into the control panel, and press down on it to lock it in place, or, secure it using the screws that were removed.
- 10
Transfer the wires from the old circuit board to the new circuit board. - 11
Reconnect the control panel ribbon connector, then snap the thermal fuse back into position. - 12
Snap the circuit board cover back into position. - 13
Replace the control panel and secure it using the screws that were removed. - 14
Close the dishwasher door and then restore power to the dishwasher.
- Advertisement -
- Advertisement -