Getting an oil change in San Francisco? You can hire a professional or go to a center, but you can also do it yourself.
If you opt for the former there are a lot of shops around the area that you can visit.
The location is actually pretty dense when it comes to smog test centers because of the strict law they have about keeping your vehicles clean so don't be surprised if you see more than three shops in one block.
However, if you prefer the latter option of doing the oil change yourself, it's also possible without further damaging your engine and ultimately your car.
There are three basic steps involved when changing your motor oil, and these are 1) preparing everything you need, 2) draining your old oil, and 3) refilling the new oil.
It does sound easy to do, but remember that the littlest mistake that's left unnoticed can pose a serious problem later on so pay attention to everything you're going to do from the start.
Preparation - before you even begin, the first thing you should do is prepare all the tools that you are going to use, from the jack stands, to the set of sockets and other stuff you need.
Your job will be much easier and quicker if you didn't have to go back and forth your tools set to get what you need.
Make sure that before you get to work, everything is all set already.
Draining the oil - this job can get a little messy.
If you're prepared to be covered in oil and soot, prepare to crawl under your car and unplug the oil drain to get all the old oil out.
After it has all been drained, check where the oil filter is.
If you haven't done this type of work before, it's usually beside the engine.
You should wear gloves just in case everything is too hot for you to touch.
Once you've changed the oil filter, make sure that everything is plugged and screwed tightly in place.
Double check if you missed anything or forgot to replace anything.
Putting new oil - this is just basically pouring in your new oil, but the thing you should remember is that you put in the required amount.
The ideal is usually about 5 quarts, but you can always check the dipstick after if you've put enough.
After you've successfully done the oil change, start the engine for a bit to gauge if everything is okay.
Check also for some possible leaks before you finish and clean up.
If you're confident that you can do this task yourself, then by all means do it.
It will save you money by putting in the effort yourself.
However, if you don't want to get messy and dirty and if you don't mind spending a little to get the job done, scout for some oil change centers in San Francisco that can get the job done for you.
If you opt for the former there are a lot of shops around the area that you can visit.
The location is actually pretty dense when it comes to smog test centers because of the strict law they have about keeping your vehicles clean so don't be surprised if you see more than three shops in one block.
However, if you prefer the latter option of doing the oil change yourself, it's also possible without further damaging your engine and ultimately your car.
There are three basic steps involved when changing your motor oil, and these are 1) preparing everything you need, 2) draining your old oil, and 3) refilling the new oil.
It does sound easy to do, but remember that the littlest mistake that's left unnoticed can pose a serious problem later on so pay attention to everything you're going to do from the start.
Preparation - before you even begin, the first thing you should do is prepare all the tools that you are going to use, from the jack stands, to the set of sockets and other stuff you need.
Your job will be much easier and quicker if you didn't have to go back and forth your tools set to get what you need.
Make sure that before you get to work, everything is all set already.
Draining the oil - this job can get a little messy.
If you're prepared to be covered in oil and soot, prepare to crawl under your car and unplug the oil drain to get all the old oil out.
After it has all been drained, check where the oil filter is.
If you haven't done this type of work before, it's usually beside the engine.
You should wear gloves just in case everything is too hot for you to touch.
Once you've changed the oil filter, make sure that everything is plugged and screwed tightly in place.
Double check if you missed anything or forgot to replace anything.
Putting new oil - this is just basically pouring in your new oil, but the thing you should remember is that you put in the required amount.
The ideal is usually about 5 quarts, but you can always check the dipstick after if you've put enough.
After you've successfully done the oil change, start the engine for a bit to gauge if everything is okay.
Check also for some possible leaks before you finish and clean up.
If you're confident that you can do this task yourself, then by all means do it.
It will save you money by putting in the effort yourself.
However, if you don't want to get messy and dirty and if you don't mind spending a little to get the job done, scout for some oil change centers in San Francisco that can get the job done for you.